|
Post by Saddle on Aug 17, 2018 17:50:41 GMT
Not the one you don't carry but someone might need.
1. Z bracket needs to redesign. Have securing bolt to the side so one can dismantle without change the mounting bolts. I should drill holes to the side so I can replace the panel in the future.
2. Give 2" more length of cable for the side by side installation. Barely enough for 7" spacing each other.
|
|
|
Post by Admin on Aug 18, 2018 21:41:41 GMT
Not the one you don't carry but someone might need. 1. Z bracket needs to redesign. Have securing bolt to the side so one can dismantle without change the mounting bolts. I should drill holes to the side so I can replace the panel in the future. 2. Give 2" more length of cable for the side by side installation. Barely enough for 7" spacing each other. Thanks for sharing your thoughts. We will evaluate your thoughts and determine what corrective action we can pursue. Keep in mind that changing product is a process and may take some time. All the best! -Renogy Team
|
|
|
Post by swampmonster on Nov 5, 2018 4:41:17 GMT
I think a total redesign of the mounting brackets is a better idea.
I think it is Grape Solar that incorporates a 2 piece clamping type bracket that you can apply anywhere along the panel edges...It is a two piece bracket that clamps the panel down tight to the lower half that gets mounted to the roof....VERY easy to install and swap panels when required.
I also think that Renogy should stop providing the self tapping screws with their Z brackets because the screws offer VERY little ability to attach their panels firmly to typical RV roofs.....Well nuts are MUCH more Superior....I know of many panels that have blown off RV roofs because of those junk screws.
|
|