Post by Admin on Oct 7, 2018 23:31:17 GMT
Apr 28, 2018 16:54:20 GMT Guest said:
I have a new 30A adventurer controller with a voltage sensor. It has no instructions on how to connect it to the battery. I see there is a black and a blue wire, and it says polarity matters. Is the black negative? Do I simply screw the wire onto the terminals? A little direction in the manual would have helped.
Thank
Apr 29, 2018 0:06:53 GMT @rabird said:
see the manual page 13, also it looks like the remote voltage sensce +/- is printed on the back of the controller next to where it plugs in.
www.renogy.com/template/files/Manuals/RNG-CTRL-ADV30-LI.pdf
Apr 29, 2018 14:44:31 GMT Guest said:
My voltage sensor wire came pre-attached to the block.It looks like the black wire has a red end piece, and the blue wire a black end (isn't that helpful), and at the other (tag) end the wires are split about 1 inch. I guess I'm supposed to strip the tag end back so I can connect to the battery terminal, and connect the black to positive and the blue to negative, but I would like some confirmation. This controller is too expensive to blow through inadequate manufacturer's instructions.