|
|
Post by TrevinLC1997 on Dec 22, 2018 1:54:43 GMT
Is there any documentation on the protocol that the Renogy BT-1 Bluetooth Module and Tracer Meter MT-1 use to grab the information from the charge controller such as current voltage, input watts, etc?
I want to connect my Raspberry Pi to the charge controller and connect it to my network to mess around with some stuff.
Thanks
|
|
|
|
Post by playersz28 on Dec 22, 2018 13:29:39 GMT
It was posted here a month or so ago in response to my request thread. I'm using a Pi to talk to my Rover using Modbus. No longer using the BT1 unless I need to set params thru my phone.
Which CC do you have?
|
|
|
|
Post by playersz28 on Dec 22, 2018 13:30:26 GMT
|
|
|
|
Post by trevinlc1997 on Dec 23, 2018 4:47:25 GMT
I'm going to use the Renogy Wanderer Li and thanks for the link! I'll give it a look.
|
|
|
|
Post by playersz28 on Dec 23, 2018 15:15:51 GMT
The Rover came with a 6pin network plug to USB cable. That works plugged into the Pi. I also made one up for testing with a long piece of 4wire cable and an old RS232 to USB adapter cable. I had no 6pin plugs so I ground down each side of an 8pin Cat5 plug until it fit in.
|
|
